Multi-Tech Systems MVP210-SS User Manual download pdf (Page 147)

100

101

MultiVOIP User Guide Technical Configuration

DID Parameters. The parameters applicable to the Direct Inward Dial

(DID) telephony interface type are shown in the figure below and

described in the table that follows. The DID interface allows one phone

line to direct incoming calls to any one of several extensions without a

switchboard operator. Of course, one DID line can handle only one call

at a time. The parameters described here pertain to the customer-

premises side of the DID connection (DID-DPO, dial-pulse originating);

the network side of the DID connection (DID-DPT, dial-pulse

terminating) is not supported.

DID Interface Parameter Definitions

Field Name Values Description

Interface DID-DPO Enables the customer-premises

side of DID functionality

DID Options MultiVOIP’s use of DID applies

only for incoming DID calls.

The Start Mode used by the

MultiVOIP must match that

used by the originating

telephony equipment, else DID

calls cannot be completed.

Start Modes Immediate Start,

Wink Start,

Delay Dial

For Immediate Start, the voip

detects the off-hook condition

initiated by the telco central-

office call and becomes ready to

receive dial digits immediately.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 414 415

Comments to this Manuals

No comments

Multi-Tech Systems MVP210-SS User Manual Page 147

Comments to this Manuals