Multi-Tech Systems MVP210-SS User Manual download pdf (Page 350)

100

101

Operation & Maintenance MultiVOIP User Guide

350

Upgrading Software

As noted earlier (see the section Implementing a Software Upgrade above),

the Upgrade Software command transfers, from the controller PC to the

MultiVOIP unit, firmware (including the H.323 stack) and settings. The

settings can be either Factory Default Settings or Current Configuration

Settings.

NOTE: To upgrade a MultiVOIP from software version 6.04 or earlier, an ftp primer

file must first be sent to the VOIP. This file is located in the

Software/ftp_Primer folder on the CD and the file name is

"FTP_Primer.bin". Before uploading this file, it must be renamed

"mvpt1ftp.bin". The VoIP will only accept files of this name. This is a

safety precaution to prevent the wrong files from being uploaded to the

VoIP. Once the primer file has been uploaded, upload the FTP firmware file.

If you accepted the defaults during the software loading process, this file is

located on your local drive at C:\Program Files\Multi-Tech

Systems\MultiVOIP 6.08 where the X is the software number and the .08 is

the version number of the MultiVOIP software on your local drive. Of

course the firmware file is named ‘mvpt1ftp.bin’.

Important: You cannot go back to 6.04 or earlier versions using FTP. You

must use ‘upgradesoftware’ via the serial port.

Important: These ftp upgrade instructions do not apply to software release

6.05 and above.

1 2 ... 345 346 347 348 349 350 351 352 353 354 355 ... 414 415

Comments to this Manuals

No comments

Multi-Tech Systems MVP210-SS User Manual Page 350

Comments to this Manuals