Multi-Tech Systems MVP210-SS User Manual download pdf (Page 72)

Mechanical Installation & Cabling MultiVOIP User Guide

Connect the other end to the trunk line.

Verify that the E&M Type in the E&M Options group of the Interface

dialog box is the same as the E&M trunk type supported by the

telephone switch. See Appendix B for an E&M cabling pinout.

For a DID connection.

(DID Example: DID fax system or DID voice phone lines.)

Connect one end of an RJ-11 phone cord to the Channel 1 FXS/FXO

connector on the back of the MultiVOIP.

Connect the other end to the DID jack.

NOTE

: DID lines are polarity sensitive. If, during testing, the DID line

rings busy consistently, you will need to reverse the polarity of

one end of the connector (swap the connections of the wires to

the two middle pins of one RJ-11 connector).

6. Repeat step 5 to connect the remaining telephone equipment to each

channel on your MultiVOIP. Although a MultiVOIP’s channels are

often all configured identically, each channel is individually

configurable. So, for example, some channels of a MultiVOIP might

use the FXO interface and others the FXS; some might use the DID

interface and others E&M, etc.

7. If you intend to configure the MultiVOIP remotely using the

MultiVOIP Windows GUI, connect an RJ-11 phone cable between the

Command Modem connector (at the rear of the MultiVOIP) and a

receptacle served by a telco POTS line. See Figure 3-9.

The Command Modem is built into the MultiVOIP unit. To configure

the MultiVOIP remotely using its Windows GUI, you must call into

the MultiVOIP’s Command Modem. Once a connection is made, the

configuration process is identical to local configuration with the

Windows GUI.

COMMAND

10 BAS ET

E&M FXS/FXO

E&M FXS/FXO E&M FXS/FXO

E&M FXS/FX O

E&M FXS/FXO

E&M FXS/FXO E&M FXS/FXO

COMMAND

MODEM

Te l c o P OT S L i ne

Grounding Screw

ETHERNET

Command Modem connector

for remote configuration

MVP-410SS/810SS

Rear Panel

Figure 3-9. MVP-410SS/810SS Voip Connections for GND &

Remote Config Modem

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 414 415

Comments to this Manuals

No comments

Multi-Tech Systems MVP210-SS User Manual Page 72

Comments to this Manuals