Multi-Tech Systems MVP210-SS User Manual download pdf (Page 38)

QS: Phone/IP Starter Config. MultiVOIP User Guide

Phone/IP Starter Configuration (continued)

12. Enable premium (H.450) telephony features.

Go to

Supplementary Services. Select any features to be used.

For Call Hold, Call Transfer, & Call Waiting, specify the key sequence

that the phone user will press to invoke the feature. For Call Name

Identification, specify the allowed name types to be used and a caller-

id descriptor.

If Call Forwarding is to be used, enable this feature in the

Add/Edit Inbound Phone Book screen.

After making changes, click on OK in the current configuration

screen before moving on to the next configuration screen.

13.

RADIUS Support. If you intend to use a RADIUS server for billing or

other accounting purposes, enter the server information in the

RADIUS screen.

14.

STUN Support. If you are using the SIP protocol with the UDP

transmission protocol, and if you want the MultiVOIP to operate

behind a NAT (Network Address Translation server) using the STUN

protocol (Simple Traversal of UDP through NAT), enable this feature

in the NAT Traversal screen. You must also specify the IP address

(etc.) of the STUN server you will use. The STUN server could be a

local device or it could be a public STUN server accessible on the

Internet.

15.

Network Locations of SIP Servers (Primary & Alternate).

Go to SIP Call Signaling and enter the IP address or domain name for the

primary SIP Server in your system, as well as any alternate SIP servers.

The UserName and Password entered here will be used to

authenticate all inbound phonebook entries that do not already have

their own unique usernames and passwords.

16.

Endpoint Info. Go to SIP Server | Predefined Endpoints.

For every other endpoint (gateway) to be registered with the

MultiVOIP-SS unit, enter values for the following parameters.

The parameters required are different for static registrations than for

dynamic registrations, as shown in the table below.

Static Registration Dynamic Registration

Endpoint Name =

IP Address:

. . .

Password:

Port #: Re-Registrat. Interval (sec):

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 414 415

Comments to this Manuals

No comments

Multi-Tech Systems MVP210-SS User Manual Page 38

Comments to this Manuals