Multi-Tech Systems MVP210-SS User Manual download pdf (Page 40)

100

101

QS: Phonebook Starter Config. MultiVOIP User Guide

Phonebook Starter Configuration (with remote voip)

If the topic of voip phone books is new to you, it may be helpful to read

the PhoneBook Tips section (page 47) before starting this procedure.

To do this part of the quick setup, you need to know of another voip

that you can call to conduct a test. It should be at a remote location,

typically somewhere outside of your building. You must know the

phone number and IP address for that site. We are assuming here that

the MultiVOIP will operate in conjunction with a PBX.

You must configure both the Outbound Phonebook and the Inbound

Phonebook. A starter configuration only means that two voip locations

will be set up to begin the system and establish voip communication.

Outbound Phonebook

1. Open the MultiVOIP program.

( Start | MultiVOIP xxx | Configuration )

2. Go to Phone Book | Outbound Phonebook | Add Entry.

3. On a sheet of paper, write down the calling code of the remote voip

(area code, country code, city code, etc.) that you’ll be calling.

Follow the example that best fits your situation.

North America,

Long-Distance Example

Euro, National Call

Example

Technician in Seattle (area

206) must set up one voip

there, another in Chicago

(area 312, downtown).

Answer: Write down 312.

Technician in central

London (area 0207) to set

up voip there, another in

Birmingham (area 0121).

Answer: write down 0121.

Euro, International Call Example

Technician in Rotterdam (country 31; city 010) to

set up one voip there, another in Bordeaux

(country 33; area 05).

Answer: write down 3305.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 414 415

Comments to this Manuals

No comments

Multi-Tech Systems MVP210-SS User Manual Page 40

Comments to this Manuals