Multi-Tech Systems MTCBA-C-EN-NX User Manual download pdf (Page 55)

Appendix C – Firmware Upgrade Using External TFTP Client

Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F) 55

Appendix C – Firmware Upgrade

Using External TFTP Client

Follow the steps below to install new firmware from the Multi-Tech Systems, Inc. Web site:

Obtaining the Latest Firmware Version

To obtain the latest version of the firmware, contact you Multi-Tech Sales Representative or contact Multi-Tech

directly by phone or email:

Phone: 763-785-3500 or 800-328-9717

See the Multi-Tech Web site: www.multitech.com

1. Open the modem/router’s Web Management software using a Web Browser. Enter the Gateway Address

http://192.168.2.1

(default) and complete the login.

2. Go to the IP Setup > General Configuration screen and check the Enable button for Firmware Upgrade

under the TFTP Configuration at the button of the screen.

3. Click Save & Restart located on the Menu bar.

4. Then open the DOS screen by clicking the PC’s Start button and selecting Programs > Accessories >

Command Prompt.

5. At the C: prompt, enter the upload request by typing the following:

tftp -i <ip-address> put <firmware-filename>-tftp.bin AMD-tftp.bin

Then press Enter.

Example: tftp -i 192.168.254.253 put c:\example.bin (Press Enter)

Definitions of the Upload Request Parameters:

• <ip-address>

Address of the Serial-to-Ethernet Adapter to which you are uploading the firmware image.

• <firmware filename>

Filename under which the firmware file was saved on your PC or local network.

• AMD-tftp.bin <>

. This is a case-sensitive file name; type it as shown here.

6. After the upgrade is completed, open the Web Management software to see if the new version shows.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60

No comments

Multi-Tech Systems MTCBA-C-EN-NX User Manual Page 55