Multi-Tech Systems MTCBA-C-EN-NX User Manual download pdf (Page 31)

Chapter 3 – Using the Web Management Software

Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F) 31

PPP > Wakeup-On-Call Examples

Example 1 – Set Up the Ethernet Router to Activate on Incoming SMS Message

Note: You must have firmware version 1.14 or above in order for Wakeup-on-Call to work.

1. On the PPP > PPP Configuration screen, set up the following parameters:

PPP General

• Make sure that PPP is Enabled (the default).

• Make sure Dial-on-Demand is Enabled (the default).

• Set the Idle Time Out to the number of seconds you desire.

Authentication

• Your wireless service provider may require you to have a separate PPP User name and

Password. If so, enter them here. Note: If a user name and password are required, your

wireless provider would have given them to you when you activated your account.

Modem Configuration

• Make sure your Dial Number is entered correctly:

For CDMA, it is #777

For GPRS and EDGE, it is *99***1#

• Make sure your Init String 1 is set up correctly.

For GPRS and EDGE, Init string 1 should be the APN.

Example: AT+CGDCONT=1,"IP","internet"

Submit

• Click the Submit button to save the changes made on this screen.

2. On the PPP > Wakeup-on-Call screen, set up the following parameters:

Wakeup-on-Call Configuration

• Select Enable for Wakeup-on-Call.

• Set the Time Delay. You can use the 10 second default.

• Enter the Init Strings:

For the EDGE modem:

Enter Wakeup Init String 1 as at+cmgf=1

Enter Wakeup Init String 2 as

at+csms=1

Enter Wakeup Init String 3 as at+cnmi=2,2,0,0,1

For the GPRS modem:

Enter Wakeup Init String 1 as at+cmgf=1

Enter Wakeup Init String 2 as at+csms=1

Enter Wakeup Init String 3 as at+cnmi=2,2,0,0,0

For the CDMA modem:

Enter Wakeup Init String 1 as at+cnmi=2,2,0,0,0

• Click the Submit button to save these settings.

Caller ID Configuration

• Enter a caller’s ID that you want added to the Caller ID list.

Note: Add the SMS message string into the Caller ID list. When the string configured

matches the SMS message string, it will activate the Wakeup-on-Call feature.

• Add Button

Click the Add button to save each Caller ID as it is entered to the Caller ID list.

Caller Acknowledgement Configuration

• Enter a configured string that will be sent to the modem upon receiving a valid Caller ID from

the WAN.

For the CDMA, GPRS, and EDGE modems:

Set the Wakeup Acknowledgement string configuration with the command at+cnma

• Click the Submit button to save the Acknowledgement Configuration.

3. Save and Restart

You must click Save and Restart once you have completed and submitted all the screens on

which you have made changes. The device will save all the settings and reboot the PC.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 59 60

Comments to this Manuals

No comments

Multi-Tech Systems MTCBA-C-EN-NX User Manual Page 31

Comments to this Manuals

Related products and manuals for Networking Multi-Tech Systems MTCBA-C-EN-NX