Multi-Tech Systems MT5600BL User Manual download pdf (Page 37)

3 Using the Front Panel

DIALBACKUP/LL OPTIONS. The following screens are used to configure dial

backup for four-wire leased line operation. For more information, see Chapter 7,

“Leased Line Operation.”

DIAL BACKUP NUMBER. Use to enter a dial backup number.

To scroll through a list of digits and characters, press the á

and â buttons. To go to the next position, press the à button.

To back up or to exit without saving, press the à button several

times. To save the number, press the Enter button.

TIME TO RESTORE (S15). Use to set how frequently leased

line restoral attempts occur when the modems are in dial back-

up mode. The restore time interval can be set from 10 to 255

minutes in one minute increments. Same as the S15= command.

DIALBACKUP TIME (S17). Use to set how long the modem

waits after a leased line failure before it attempts a dial backup

connection. The timer can be set from 1 to 255 minutes in one

minute increments. Same as the S17= command.

CALLBACK SECURITY. Use the à and Enter buttons to turn callback security on

or off. Same as the #DB0 and #DB1 commands. For more information about callback

security, see Chapter 6, “Callback Security.”

PASSWORD SETUP. Use to enter callback security passwords

in memory locations 1–30. Each password must be six to ten

characters in length. To scroll through a list of digits and charac-

ters, press the á

and â buttons. To go to the next position,

press the à button. To back up or to exit without saving, press

the à button several times. To save the password, press the

Enter button. Same as the #CBP= command.

CALLBACK NUMBER. Use to enter callback security phone

numbers in memory locations 1–30. Each number can be up to

30 characters long. Same as the #CBN= command.

Remote Configuration Options

The following screens are used to configure remote configuration options. For more

information about remote configuration, see Chapter 5, “Remote Configuration.”

ENABLE/DISABLE R.C. Use the à and Enter buttons to turn

remoteconfiguration on or off.

REMOTE CONFIG. PASSWORD. Use to enter the remote con-

figuration password. To scroll through a list of digits and char-

acters, press the á

and â buttons. To go to the next position,

press the à button. To back up or to exit without saving, press

the à button several times. To save the password, press the

Enter button.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 117 118

Comments to this Manuals

No comments

Multi-Tech Systems MT5600BL User Manual Page 37

Comments to this Manuals

Related products and manuals for Fax machines Multi-Tech Systems MT5600BL