Multi-Tech Systems RAS96 User Manual download pdf (Page 76)

RAS96 RASCard User Guide

CommPlete Communications Server68

ERROR ENCOUNTERED INITIALIZING HARD DRIVE

The hard disk cannot be initialized. Make sure the adapter is installed correctly and all

cables are correctly and firmly attached. Also, make sure the correct hard disk type is

selected in Setup.

ERROR INITIALIZING HARD DISK CONTROLLER

Cannot initialize controller. Make sure that the correct hard disk type is selected in

Setup. Also check to see if a jumper needs to be set correctly on the hard disk.

FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT

Cannot find or initialize the floppy drive controller. If there are no floppy drives

installed, be sure the Diskette Drive selection in Setup is set to NONE.

KEYBOARD ERROR OR NO KEYBOARD PRESENT

Cannot initialize the keyboard. Make sure the keyboard is attached correctly, and no

keys are being pressed during the boot.

If you are purposely configuring the system without a keyboard, set the error halt

condition in Setup to HALT ON ALL, BUT KEYBOARD. This will cause the BIOS to

ignore the missing keyboard and continue the boot.

Memory Address Error at ...

Indicates a memory address error at a specific location. You can use this location along

with the memory map for your system to find and replace the bad memory chips.

Memory parity Error at ...

Indicates a memory parity error at a specific location. You can use this location along

with the memory map for your system to find and replace the bad memory chips.

MEMORY SIZE HAS CHANGED SINCE LAST BOOT

Memory has been added or removed since the last boot. Enter Setup and enter the new

memory size in the memory fields.

Memory Verify Error at ...

Indicates an error verifying a value already written to memory. Use the location along

with your system’s memory map to locate the bad chip.

OFFENDING ADDRESS NOT FOUND

This message is used in conjunction with the I/O CHANNEL CHECK and RAM

PARITY ERROR messages when the segment that has caused the problem cannot be

isolated.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 82

No comments

Multi-Tech Systems RAS96 User Manual Page 76