Multi-Tech Systems RAS96 User Manual Page 31
- Page / 82
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
4 BIOS Setup Utility
CommPlete Communications Server 25
You can use the IDE HDD Auto Detection option in the main menu to automatically
enter the specifications for your hard disk. If you wish to configure your drive
manually, press PAGE UP or PAGE DOWN to select User. Enter your drive’s
specifications in the drive table. The hard disk will not work properly if you enter
improper information.
If you select User, you will need to know the following information. Enter the
information directly from the keyboard and press ENTER. This information should be
included in the documentation from your hard disk vendor or the system
manufacturer.
CYLS
Number of cylinders
.
HEAD
Number of heads
.
PRECOMP
Write
precompensation
.
LANDZ
Landing zone
.
SECTORS
Number of sectors
.
MODE IDE mode: Normal, for drives under 528 MN; LBA, for larger drives
that support Logical Block Addressing (most IDE drives over 528
MB); Large, for drives over 528 MB that do not support LBA
(uncommon); and Auto, for autoselection on boot-up (default).
If a hard disk has not been installed, select None and press ENTER.
Drive A Type / Drive B Type
This category identifies the types of floppy disk drives that have been installed in the
computer.
None
No floppy
d
rive installed
.
360K, 5.25 in
5.25-inch PC-type
standard drive, 360-kilobyte capacity
.
1.2M, 5.25 in
5.25-inch AT-type
high-density
drive, 1.2-megabyte capacity
.
720K, 3.5 in
3.5-inch
drive, 720-kilobyte capacity
.
1.44M, 3.5 in
3.5-inch drive, 1.44-megabyte capacity (default – drive A)
.
2.88M, 3.5 in
3.5-inch
drive, 2.88-megabyte capacity
.
Video
The category selects the type of video adapter used for the primary system monitor.
Although secondary monitors are supported, you do not have to select the type in
Setup.
EGA/VGA Enhanced Graphics Adapter/ Video Graphics Array. For EGA,
VGA, SEGA, SVGA or PGA monitor adapters (default).
CGA 40 Color Graphics Adapter, power-up in 40 column mode.
CGA 80 Color Graphics Adapter, power-up in 80 column mode.
MONO Monochrome adapter, includes high resolution monochrome
adapters.
- RAS96 RASCard - E1 1
- User Guide 1
- Important Safety Instructions 3
- Table of Contents 4
- 1 Introduction 7
- Manual Organization 8
- Technical Specifications 9
- RAS96 RASCard User Guide 10
- 2 RASCard Description 11
- Introduction 12
- Memory Banks 12
- J17 Watchdog Timer 13
- Internal Connectors 14
- External Connectors 15
- Front Panel 16
- Switches 17
- 3 Installation 19
- Safety Warnings 20
- Pre-Installation Notes 20
- Installation Procedure 20
- 4 BIOS Setup Utility 23
- Using Setup 25
- Getting Help 25
- In Case of Problems 25
- Main Menu 26
- PCI Configuration Setup 27
- Password Setting 27
- Load BIOS Defaults 27
- Load Setup Defaults 28
- IDE HDD Auto Detection 28
- Save and Exit Setup 29
- Exit Without Saving 29
- Standard CMOS Setup 30
- Drive A Type / Drive B Type 31
- BIOS Features Setup 33
- Gate A20 Option 35
- Memory Parity Check 35
- Typematic Rate Setting 35
- Typematic Rate (Chars/Sec) 35
- Typematic Delay (Msec) 36
- Security Option 36
- Video BIOS Shadow 36
- Chipset Features Setup 37
- On-Chip Primary PCI IDE 39
- PCI Concurrancy 39
- PCI Streaming 39
- PCI Bursting 39
- Power Management Setup 40
- Power Down Activities 42
- COM Ports Accessed 42
- LPT Ports Accessed 42
- Drive Ports Accessed 42
- PCI IRQ Activated by 44
- PCI IDE IRQ Map to 44
- 5 E1 Daughter Cards 47
- Specifications 48
- E1 Overview 48
- E1 Glossary 49
- E1 Basics 50
- E1 Frame Formats 51
- E1 Line Coding 51
- Signaling Options 51
- DNIS digits 51
- Country Selection 52
- E1 Facility Termination 53
- PCB Description 54
- Ordering an E1 Line 55
- E1 Commands 57
- 5 E1 Daughter Card 59
- E1 Command Messages 61
- E1 Status LEDs 61
- Functional Description 62
- 6 Solving Problems 63
- Troubleshooting 64
- Invalid time, date or setup 65
- Memory Upgrade 66
- Diagnostic Tests 67
- Calling Technical Support 67
- Appendixes 69
- Keyboard Connector (J11) 70
- Video Connector (J35) 70
- COM1 Connector (J3) 71
- E1 Alarm Connector (J22) 71
- Drive Power Connector (J13) 72
- Hard Disk Connector (J6) 73
- IDE Connector (J21) 74
- Appendix B POST Messages 75
- OFFENDING SEGMENT: 77
- PRESS A KEY TO REBOOT 77
- Appendix C POST Codes 78
- C POST Codes 79
- Appendix D Approved Memory 81
© 2020, manymanuals.com. All rights reserved. | 3.161 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals